Installing Module Into Matrix E7 Or Matrix N7 Chassis (E7 Shown) - Enterasys Matrix 7H4284-49 Hardware Installation Manual

Installing DFE Module into Matrix E7 or N7 Chassis
5. If the chassis in which the module is installed was powered down for the installation, turn the
power supplies on. Check to see that the module CPU LED settles at solid green after a few
minutes. If the LED does not turn solid green, refer to
Figure 3-2 Installing Module into Matrix E7 or Matrix N7 Chassis (E7 shown)
Card guides
1
2 Slot number 6 (Left-most slot is 1)
3 Module card
4 Metal back panel
3-8 Installation
Æ Á
Â
Ã
À
5 Upper/lower locking tabs (in proper open position)
6 Upper/lower locking tab (in closed position)
7 Backplane connectors
- Top two connectors (power and FTM2)
- Bottom two connectors (power and FTM1)
(no bottom connectors in Matrix N7 chassis
Chapter 4 for troubleshooting details.
SERIES
Å
Å
Ä
Ä
)