Connecting To The Network; Installing Module Into Matrix N1, N3, Or N5 Chassis (N3 Shown) - Enterasys Matrix 7H4284-49 Hardware Installation Manual

Connecting to the Network

Figure 3-3 Installing Module into Matrix N1, N3, or N5 Chassis (N3 shown)
Æ
Ä
1 Card guides
2 Slot 1 (Top slot is slot 3.)
3 Module card
4 Metal back panel
3.6 CONNECTING TO THE NETWORK
This section provides the procedure to connect fiber-optic segments from the fixed front panel
MT-RJ port connectors to the network or other devices
Note: If the DFE module is being installed in a network using Link Aggregation, there
are rules concerning the network cable and port configurations that must be followed for
Link Aggregation to operate properly. Before connecting the cables, refer to the
Enterasys Matrix DFE-Platinum Series Configuration Guide for the configuration
information. For details on how to obtain manuals, refer to the
About This Guide
3-10 Installation
À
5 Upper locking tab (shown in closed position)
6 Lower locking tab (shown in closed position)
7 FTM2 backplane connectors
.
Ã
Â
(Section 3.6.1).
Á
Å
"Related Documents" in