Programming At The Beltpack; Introduction To Programming On The Beltpack; Selection Of Key And Page - Clear-Com ECLIPSE DIGITAL WIRELESS User Manual

2
E C L I P S E W I R E L E S S C O M M U N I C A T I O N S Y S T E M
PROGRAMMING AT THE
BELTPACK
INTRODUCTION TO PROGRAMMING ON THE BELT-
PACK
In programming the Beltpack, the general considerations are:
• It is necessary to have a radio connection to be able to engage programming
mode. It is not generally possible to enter programming mode unless the
normal working display is present.
• To access the main programming menu, hold both the UP and DOWN
keys pressed together for at least 3 seconds. This calls up the main
programming menu.
• The Beltpack saves programming data when you press enter on a menu
which does not have an UP arrow at the right hand end. To exit without
saving, press the UP and DOWN buttons simultaneously for 3 seconds.
• Generally buttons auto-repeat when held pressed.
• The "cursor" is the highlighted item and it cycles round to the other end of
the menu when it reaches one end.
• The icon shown in a box is the currently selected item.
• If the right hand end of the menu contains an UP arrow, selecting this and
pressing Enter will take you back up one level in the menu structure and
will eventually return you to the main working display.
• The backlight times out after 15 seconds.
The menus in Program Mode are presented graphically as a menu map. The
screen pictures shown in this document refer to beltpacks running V4A or later
of the firmware. Beltpacks with different versions of the firmware may display
slightly different screens.

SELECTION OF KEY AND PAGE

Several areas of the programming set up a mode or function on a particular key.
It is, therefore, necessary to select both the key and the page on which it appears
prior to entering the required programming menu. The 'Select Assignment'
display (below)
2 - 1