Kongsberg Simrad SU90 Operator's Manual page 222

Simrad SU90 Operator Manual
–
Transceiver
The
Transceiver
SU90 system.
–
Transducer
By means of the
during normal operation. Any errors are then easily detected.
–
Noise
The operational performance of the SU90 system depends on the noise conditions.
It is essential that the noise signature is as low as possible.
•
Export
The page allows you to export user settings, configuration files, message logs
Export
and information mainly related to hardware and software troubleshooting.
•
Installation
Before you use the SU90 system you must set it up to communicate with the relevant
peripherals. This includes the transducer. Use the
interfaces with external devices, and to set up basic parameters related to installation
and operation. In most cases, you only need to do this once.
–
Sensor Installation
For the SU90 system to use and offer correct navigational information, one or
more external sensors must be connected. Typical sensors are those providing
navigational information (heading, speed or geographical position). Use the
page to define which external sensors your SU90 system will import
Installation
information from. You must also specify which datagram formats to use. For each
relevant sensor you must insert the offset values that define the its physical location
relative to the vessel's coordinate system.
–
Sensor Configuration
With multiple sensors connected to the SU90 system, many of them will provide
the same datagrams. We cannot expect that these datagrams provide the same
information. The
priority, so that the information from the "most reliable" sensor is used by the
SU90 system. You can also define manual values in case a sensor is unserviceable,
or not installed.
–
I/O Setup
To communicate with peripheral devices the Processor Unit offers several serial
and/or Ethernet (LAN) ports. The number of communication ports depends on
how your Processor Unit is set up and configured. The parameters on the
page allow you to control the properties of each of the available communication
ports. For each port, you can set up the communication parameters, and monitor
the data flow.
220
page offers key information about each transceiver in use by the
page you can check the impedance of each transducer
Transducer
Sensor Configuration
dialog box to set up all
Installation
page allows you to define a datagram
Sensor
I/O Setup
381291/D