Kongsberg Simrad SU90 Operator's Manual page 137

• The new sensor is physically connected to the SU90 system using a serial or network
cable. The sensor is turned on and in normal operation.
Neither tools nor instruments are required.
Context
Note
The input from a course gyro is essential for operation. Without the input from a course
gyro, the SU90 system will not be able to present correct navigational information.This
lack of compensation will prevent the system from providing correct echo information.
The
Sensor Installation
sensors and systems. You must specify which communication port to use (LAN (Local
Area Network) or serial port). You can type a custom name to identify the sensor import.
In the list of valid datagram formats, select the format(s) to be accepted by the SU90
system. For each relevant sensor you must insert the offset values that define the its
physical location relative to the vessel's coordinate system.
Note
Just making changes and selecting
Select what to install, define the relevant parameters, and then select
Procedure
1 Connect the gyro (or other heading sensor) to an available communication port
on your computer.
This is described in the Installation Manual.
2 Open the
Setup
3 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
4 On the left side of the
5 For
Sensor Type
6 Select which port you want to import the sensor information on.
7 If you want to check the communication parameters, select
Note
You cannot make any changes here. To change the communication parameters,
use the
I/O Setup
381291/D
page allows your SU90 system to communicate with external
at the bottom of the page will not install anything.
OK
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
, select Gyro to import information from a global positioning system.
page.
.
Sensor Installation
Maintenance procedures
.
Add
.
.
Inspect Port
135