Kongsberg Simrad SU90 Operator's Manual page 168

Simrad SU90 Operator Manual
Tip
An Ethernet switch connected to ETH1 on the rear side of the Processor Unit can also be
used to interface other peripheral systems such as echo sounders and positioning systems.
You can also connect the Olex system to the SU90 system using this Ethernet switch.
2 Open the Operating Panel configuration page.
a On the Operating Panel, press
The blue indicator light in the button flashes while the Operating Panel
establishes contact with the Processor Unit. When the connection has been
made, the blue indicator light is lit permanently.
b On the Processor Unit, close any programs that are running, and return to
the desktop.
c On the Processor Unit desktop, open folder
d Double-click the URL shortcut to open the Operating Panel configuration page
in the default web browser.
Note
If you have previously changed the IP Address on the Operating Panel, you
must use this address to open the configuration page.
For each Processor Unit that is added:
3 Locate the IP and MAC addresses on the ETH1 Ethernet adapter in the Processor
Unit.
The IP and MAC addresses for your Processor Unit are contained in a text file
named
IPandMACaddress.txt
information manually.
Obtain the IP address.
a In the bottom-left corner of your desktop, select the Windows
b On the menu, select
c Observe that the
d Select
Network & Internet
e Select
Change adapter options
f Select the relevant network adapter, then right-click and select
the short-cut menu.
g On the list of connections, select
.
Properties
h Observe the IP address for the Ethernet adapter.
i Write down the information.
j Close all the dialog boxes.
166
, and keep it depressed for a few seconds.
Power
. If the text file is missing you must find the
.
Settings
dialog box opens.
Windows Settings
.
.
Internet Protocol 4 (TCP/IPv4)
.
SIMRAD-Shortcut
®
Start
Properties
, and then
button.
on
381291/D