Kongsberg Simrad SU90 Operator's Manual page 175

Procedure
1 Make sure that you have sufficient water depth below the keel before you lower
the transducer.
2 Lower the transducer to its bottom position.
3 Select the default settings.
a On the
Main
b Observe the
c Select the setting you want to use.
d Select
Activate Selected Setting
e Select
OK
4 Make the following preparations.
a On the
Main
b On the
Operation
to start pinging.
c On the
Setup
5 Select
Transceiver
The
Transceiver
The visual presentation reflects the physical location of the boards in the Transceiver
Unit. Only static information is provided. The
key information about the supply power to the selected transceiver board, as well as
the environmental conditions.
To select a transceiver board, click the "button". Relevant information about the
selected transceiver board is provided under
To disable or enable a transceiver board, right-click the "button" and use the
short-cut menu.
Each button provides a small colour coded indicator.
• : Status is OK. No actions are necessary.
No indicator
• : This is a warning. A closer investigation is recommended.
Yellow
• : This is an alarm. A closer investigation is required.
Red
• : A device monitored by the diagnostic system is disabled.
Blue
• : No information is available.
Grey
6 Make sure that all the 12 transceiver boards are fully functional.
7 Finish the test.
a Close the
BITE
b Set
Tx Power
c Hoist the transducer back up to its upper position.
381291/D
menu, select
User Settings
list.
Factory Settings
.
to apply your changes and close the
menu: Set to 1500 m.
Range
menu: Set
Tx Power
menu: Open the
BITE
to open the page.
page provides a graphic presentation of the 12 transceiver boards.
(Built In Test Equipment) dialog box.
to Off.
Maintenance procedures
.
User Settings
to Maximum (or any other power rating)
(Built-In Test Equipment) dialog box.
Board Information
Board Information
dialog box.
parameters offer
.
173