Kongsberg Simrad SU90 Operator's Manual page 133

Procedure
1 Connect the navigation system to an available communication port on your
computer.
This is described in the Installation Manual.
2 Open the
Setup
3 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
4 On the left side of the
5 For , select the GPS sensor to import information from a global positioning
Type
system.
6 Select which port you want to import the sensor information on.
7 If you want to check the communication parameters, select
Note
You cannot make any changes here. To change the communication parameters,
use the
I/O Setup
8 If you want to check that the peripheral system is transmitting data to the SU90
system, select
Monitor
The
Port Monitor
), and one for outgoing messages (
Data
knowledge of the data communication to investigate the datagrams. The
dialog box is a tool for debugging purposes. It is neither required nor
Monitor
intended for normal operation of the SU90 system.
9 Type a custom name to identify the interface in other dialog boxes.
10 Select which datagram(s) you want to import from the sensor.
11 If relevant, specify a dedicated talker ID.
12 Provide the accurate physical location of the sensor (or its antenna) with reference
to the vessel's coordinate system.
The position of certain sensors must be defined as an offset to the Ship Origin in the
coordinate system to maximize performance. These offset values are all required
to allow the SU90 system to give you as accurate information as possible. The
degree of accuracy offered by the SU90 is directly related to the accuracy of the
information you enter on the
381291/D
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
page.
.
dialog box provides one text box for incoming messages (
Sensor Installation
.
Sensor Installation
). Use these boxes and your
Tx Data
page.
Maintenance procedures
.
.
Inspect Port
Rx
Port
131