Kongsberg Simrad SU90 Operator's Manual page 143

Note
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Procedure
1 Connect the synchronization cable from the remote system to an available
communication port on your computer.
This is described in the Installation Manual.
2 Turn on the SU90 system and set it to normal use.
3 Open the
Setup
4 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
5 On the left side of the
6 Select
Synchronization Mode
• Stand-alone
Synchronization is turned off.This synchronization mode is used if the SU90
system is working by itself and with no synchronization required. This is the
default setting. The SU90 system operates using its internal ping interval
parameters, independent of any trigger signals arriving at the synchronization
port.
The
Synchronization Delay
switched off.
• Master
Master mode is used if the SU90 system is going to act as the controlling unit
in a synchronized system. The peripheral hydroacoustic system(s) are only
permitted to transmit when enabled by the SU90 system. When Master mode is
selected, the SU90 system will run using its internal ping interval parameters
and send trigger signals to the peripheral system(s).
This mode is unavailable if you set
Port.
• Slave
The Slave mode is used if the SU90 system shall transmit only when permitted by
a peripheral system. When the Slave mode is selected, the SU90 system will not
transmit ("ping") unless an external trigger appears on the chosen synchronization
381291/D
dialog box, you must always select
Installation
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
.
setting is not applicable when synchronization is
.
Synchronization
Synchronization Port
Maintenance procedures
to save the
Apply
.
to Transceiver Auxiliary
141