Kongsberg Simrad SU90 Operator's Manual page 148

Simrad SU90 Operator Manual
The 0° transducer mark is located outermost on the mounting flange, and it is marked as
a red "0". Depending on the transducer mounting, it can be located at any angle on the
mounting flange, not necessarily as shown in the illustration.
On the page, define this angle as rotation around Z.
Transducer
• If the 0° transducer mark points to the starboard (right) side of the vessel's centre line,
insert the alignment as a number between 0 and +180 degrees.
• If the 0° transducer mark points to the port (left) side of the vessel's centre line (as
shown in the illustration), insert the alignment as a number between 0 and –180
degrees.
Illustration:
Rotation around the
A
x-axis: In the positive
horizontal direction
(forward), a positive
rotation is clockwise.
Rotation around the
B
y-axis: In the positive
horizontal direction
(starboard), a positive
rotation is clockwise.
Rotation around the z-axis: In the positive vertical direction (down), a positive
C
rotation is clockwise.
Reference point (Ship Origin)
D
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side of the
Installation Parameters
Observe that a menu opens with access to all the individual pages.
4 Select
Transducer
146
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select the small white triangle next to
Installation
.
to open the page.
.
381291/D