Controls Functions - Baileigh Industrial SH-120250-HD Operator's Manual

CONTROLS FUNCTIONS

A
A YSD6000
DRO (Digital Read
B
Out)
C Shadow Lamp
D Rake Angle Minus (-) Reduces the rank angle of the upper blade.
E Rake Angle Plus (+)
F Motor Stop Button
G NC Key Switch
Cutting Stroke
H
Control Knob
Used to set and store bending parameters for either single or
programmed usage.
Displays the rake angle of the upper blade in degrees as
compared to the lower stationary blade. This is a display and
does not program or control the rake angle.
When turned On, this will produce a shadow line at the point
that the material will be cut. This can be used to align the
material to the cut point.
Increases the rank angle of the upper blade.
Stops the hydraulic pump motor operation.
Provides power to the YSD6000 Controller.
Controls the ram down travel (stroke) during the cutting
process. Turning the knob fully counterclockwise will limit the
ram travel to only small portion of the blade on the left end of
the blade will produce a cut. Turning the knob fully clockwise
will allow the ram to travel down the full stroke and cut material
over the entire length of the blade.
22
22
C D
G H
K
B
E
F
J
I
L