Appendix B Alarm List - Baileigh Industrial SH-120250-HD Operator's Manual

Appendix B Alarm List

Alarm NO. Alarm Information
A.01 Pieces reached
A.02 X Pos <minimum
A.03 X Pos >maximum
A.04 G Pos <minimum
A.05 G Pos >maximum
A.06 Out of UDP
A.08 X Out of limit.
Slider Block (Ram)
A.11
err.
A.12 Finished work
A.22 Mach. Not ready
A.23 Encoder abnor.
A.24 Comm. Err.
A.25 X-axis Dropped
A.27 Can Send Err.
A.29 Safe ln Err.
A.30 Power Drop
AX.60-
CAN Error
AX.67
Alarm Description
Normal message, that the count reaches a preset value.
The current position of X-axis is out of the minimum value,
it is necessary to move the X-axis to the soft limit range
manually.
The current position of X-axis is out of the maximum value,
it is necessary to move the X-axis to the soft limit range
manually.
The current position of G-axis is out of the minimum value,
it is necessary to move the G-axis to the soft limit range
manually.
The current position of G-axis is out of the maximum value,
it is necessary to move the G-axis to the soft limit range
manually.
Move the cutter to the Upper Dead Point by foot switch.
When the X-axis is employed for the front feed, the current
position of X-axis is out of the soft limit range.
It is necessary to move the X-axis to the soft limit range
manually.
The slider (ram) is not on the TDC in the case of
positioning. Move the ram to the Upper Dead Point by foot
switch.
Normal message when the count reaches the preset value.
Requires operator to manually clear alarm.
Need to start the hydraulic pump power.
The voltage of encoder is abnormal. Check wiring,
connections and signal voltage.
Can communication is abnormal, please check whether the
communication port ground is well.
The X-axis driver is missing. Reboot the system and try
drive again.
The device is not connected to the drive. Check and
connect the drive.
Light signal loss on the BEND stage, check the screen
input signal with or without object light signal.
The system voltage is lower than the normal value, check
whether the system voltage is normal.
The X-axis CAN communication is abnormal, restarting the
system after clearing the alarm.
52
52