Operation Procedure; Shearing Stroke Adjustment (Shearing In Section); Shadow-Line Cutting - Baileigh Industrial SH-120250-HD Operator's Manual

Operation Procedure

1. Turn ON the main power disconnect switch and press the motor start button to start the
motor.
2. If not already completed during the wiring, inspect if the motor is rotating in the correct
direction as by the arrow on the motor fan cover. If not, stop the motor and change the wiring
immediately.
3. Adjust the blade gap clearance using the handwheel to the left of the control panel. Rotate
the handwheel until the pointer is pointing at the material thickness dimension for the
material to be cut.
4. Adjust the rake angle for the thickness of material to be cut. The rake angle is best set at the
lowest angle that will provide a cut.
5. Adjust the shearing stroke based upon the width of the material to be cut.
6. Run the beam down and back up at least one stroke before beginning to cut material.
7. Recheck the adjustments and when the machine has been adjusted for the material to be
cut, shearing can be started.

Shearing Stroke Adjustment (shearing in section)

1. Using the adjustment knob (H), the shearing stroke of cutting beam can set to cut a few
inches wide up to the full width of the blade. You can choose a small shearing stroke for
cutting a workpiece with smaller width to shorten the shearing time and increase efficiency.
2. Rotate the shearing stroke knob counterclockwise to shorten the stroke and clockwise to
increase the stroke.

Shadow-line Cutting

Turn the shadow-line lamp ON and verify that the shadow line is exactly in line with the cutting
edge of the blade.
If not, the adjustment must be made as following:
1. Loosen the lamp support screws.
2. Move the lamp support forward or backward until the lamp light is aligned with the cutting
edge.
3. Hold the lamp in position and tighten the support screws.
24
24