Alarm - Baileigh Industrial SH-120250-HD Operator's Manual

ALARM

The device can detect internal or external abnormalities automatically and send out alarm
prompt. The alarm messages are available on alarm list.
Operation steps
1. On the programming management page, press the
constant page.
2. On the programming constant page, press the
page to view all alarm history.
As shown in Figure 3-1, the latest 6 alarms, alarm number, and causes can be viewed on this
page.
Figure 3-1 Alam1 history page
Alam1 history and message is shown in Table 3-1.
Table 3-1 Alarm number and alarm message
Alarm Number
A.01
A.02
A.03
A.11
A.12
A.21
A.22
A.41
A.42
A.43
ALARM RECORD
A.24
Alarm Name
Count reached prompt
Minimum soft limit
Maximum soft limit
Count reached shut-down
Beam is not on upper dead point
Oil pump not started
Encoder failure
Parameter storage error
Abnormal power failure
System self-checking error
button to enter programming
arrow button to enter "Alarm History"
Mach. Not ready
Alarm Description
Count reaches preset value
Minimum soft limit
Maximum soft limit
When count reaches preset value,
system shut down automatically.
In single step and multistep mode,
beam is not on upper dead center.
Oil pump signal loss
Encoder voltage is too low.
-
-
-
48
48