Operation Examples - Baileigh Industrial SH-120250-HD Operator's Manual

Start and Stop
After finishing the programming, press
The device starts, the green indicator light will be on.
Only on the SINGLE page, PROAGRAM page or STEP page, the machine can run after
pressing . In other pages, press
When there is any alarm, the machine cannot start until the alarm is clear, the machine can then
start again.
Press to stop the machine immediately. At the same time, the page on the device moves
backs to the previous programming page.
The device does not start, the red indicator light will be on.
Parameter Setting
When editing the parameter, press the
parameter you want to modify. Input the value and press the
When editing the parameter, please review the tip in the status bar at the bottom of the screen.
If the value is out of range, the tip will display "Out of range". Input a correct value to correct.
Alarm Reset
When there is any alarm, the machine stops immediately. If you want to recover the machine's
operation, you need to clear the alarm.
On the CONST page, press
recent alarm information will display from the top down. Use the information within the status bar
at the bottom of the screen to progress through the problem. Then press the
enter button to clear the alarm. The machine is then ready to return to operation.

OPERATION EXAMPLES

Single Step
Used when the material being processed into workpieces have the same length. For this
example, we use 6 inches.
• Length of each workpiece is 6"
• Gap is Not used. Set the gap manually with handwheel.
• Distance of retracting is 0.2"
• Time for the back gauge retract delay is 2.00sec.
• Workpiece is 10.
to run the device.
to run is invalid.
, ,
arrow button to enter the ALARM RECORD page. The most
35
35
, or arrow buttons to select the
enter button to finish.
reset and then