Table of Contents
Advertisement
ELECTRICAL SYSTEM OPERATION
CAUTION:
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy materials make sure they are properly supported.
Main power switch
Turn the main disconnect switch QS located on the back side of electrical cabinet ON, the
power indicator HL1 lights. The operating control circuit is energized.
NC Controller Start
Turn the NC Key switch to the ON (1) position and allow the YSD6000s controller to power on
and complete the boot up cycle.
Motor start of main oil pump
Push and hold briefly the green start button SB2. The button of the switch will illuminate and the
hydraulic pump motor (main motor) will start and run.
Motor stop of main oil pump
Push the red stop button SB1. The main motor stops and the green indicator HL2 turns off.
Always wear proper eye protection with side shields, safety
28
28
Advertisement
Table of Contents
Troubleshooting
