Guards And Light Curtains - Baileigh Industrial SH-120250-HD Operator's Manual

Guards and Light Curtains

1. Unpack the left and right back guards and the support
pads.
2. Install the support pads into each guard so that at least 1"
(25mm) of thread is in the guard and the pad.
3. Set the initial length of the pad to be about 10" (254mm)
from the bottom edge of the guard. This will be adjusted
at the end of the installation.
4. Remove and use the four mounting bolts in the frame to
attach the guards to the frame.
5. Adjust the support pads to just contact the floor and then
add 1/2 turn additional down (extending) to provide the
support to the end of the guard.
6. Lock the jam nuts in place.
7. On the left (electrical cabinet end) end of the shear, route
the wire harnesses for the light emitters through the
stiffener channel and connect the plugs.
8. The plug connections are PC1-T to PC1-T and PC2-T to
PC2-T.
9. Connect the plug PC1-T and PC2-T.
10. Install the emitters onto the inside of the left (electrical
cabinet) side back guard so that they are to toward the
machine and pointing toward the far end of the machine.
Note: Typically, the emitter connected to PC1-T
is mounted on top and the PC2-T emitter is mounted low. As
long as the wires reach easily from the channel to the
emitter, the top or bottom position does not matter.
Note: When tightening the mounting brackets to
the guard tube, slide the bracket inboard toward the shear as
far as possible.
17
17