Baileigh Industrial SH-120250-HD Operator's Manual page 59

The procedures for the readjustment of blade clearance:
1. Reduce the rake angle until the upper blade is parallel to the lower blade.
2. Turn the main motor off and loose slowly the braking valve (No. 13) (see the hydraulic
scheme) until the upper and lower blades are overlapped for 1mm and then tighten the
valve.
3. Set the blade clearance to the minimum and then adjust it through the bolts on the table so
that the blades can come together or go apart.
4. Check the blade clearance with a feeler of 0.05mm which is the maximum permitted value
for it.
5. Restart the main motor, filled oil to the accumulator and readjust the rake angle on the
request.
NOTES
56
56