High Speed Interface Configuration Menu Screen - Cabletron Systems SmartSwitch 2H22 Supplemental Manual

To set the Operational Mode for individual ports, proceed as follows:
1. Use the arrow keys to highlight the Operation Mode field adjacent to
the number of the port(s) that you plan to change.
The Operation Mode for the first 12 ports can be changed on
NOTE
the first screen. To display the Operation Mode for additional
groups of twelve ports (13 – 24, 25 – 36, and 37 – 48), use the
arrow keys to highlight the Ports [xx-xx] field and press
ENTER.
2. Press the SPACE bar until the appropriate mode, FULL DUPLEX or
STANDARD ENET displays in the field.
3. Use the arrow keys to highlight the SAVE command on the bottom
line of the screen.
4. Press ENTER. The message "SAVED OK" displays.
To set the Operation Mode for all ports (1-24, or higher), proceed as
follows:
1. Use the arrow keys to highlight the SET ALL PORTS field.
2. Press the SPACE bar until you see FULL or STANDARD.
3. Use the arrow keys to highlight the SAVE command on the bottom
line of the screen.
4. Press ENTER. The message "SAVED OK" displays.
1.8 HIGH SPEED INTERFACE CONFIGURATION MENU
SCREEN
This High Speed Interface Configuration Menu screen does not
NOTE
display unless an optional interface module is installed: one or
two Fast Ethernet Interface Modules, or High Speed Interface
Module (HSIM), depending on what the host SmartSwitch
supports.
The High Speed Interface Configuration Menu screen,
to the Fast Ethernet Interface Modules and the High Speed Interface
Module.
Local Management Supplement
High Speed Interface Configuration Menu Screen
Figure 1-9, applies
1-19