Cabletron Systems SmartSwitch 2H22 Supplemental Manual page 33

PORT #
1
2
3
4
5
6
7
8
9
10
11
12
SAVE SET ALL PORTS: FULL
Figure 1-8 Ethernet Full Duplex Configuration Screen
This section explains each field of the Ethernet Full Duplex Configuration
screen.
PORT # (Read-only)
Identifies the number of the port.
OPERATION MODE (Toggle)
Allows the user to set the specified port to transmit and receive data
separately (Standard) or simultaneously (Full Duplex). Set this field to
one of the following values:
• STANDARD ENET – The port is running in half duplex (default) and
either transmits data or receives data, but not both at the same time. To
set Ethernet ports for Standard operation, refer to
• FULL DUPLEX – Depending on the SmartSwitch, the port transmits
and receives data simultaneously at 10 or 100 Mbps, thus enabling the
port to effectively switch at 20 or 200 Mbps. To set Ethernet ports for
Full Duplex operation, refer to
Local Management Supplement
Ethernet Full Duplex Configuration Screen
OPERATION MODE
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
LINK STATUS
Link
Link
Link
No Link
Link
Link
Link
Link
Link
Link
Link
Link
EXIT [13-24]
Section 1.7.1.
PORT STATUS
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
RETURN
RETURN
Section 1.7.1.
19601-21
1-17