Garp Operation Status Screen - Cabletron Systems SmartSwitch 2H22 Supplemental Manual

Chapter 4: Generic Attribute Registration Protocol (GARP)
4.3

GARP OPERATION STATUS SCREEN

The GARP Operation Status screen,
the switch as GMRP- and GVRP-aware ports. The ports may be enabled
one by one or all at the same time for GMRP and GVRP.
To access the GARP Operation Status screen, use the arrow keys to
highlight the GARP OPERATION STATUS menu item on the 802.1
Configuration Menu screen and press ENTER. The GARP Operation
Status screen displays.
Port #
1
3
5
7
9
11
13
15
17
19
GMRP Protocol:
SAVE
The following describes the screen fields.
Port # (Read-Only)
Displays the number of the front panel interface.
GMRP (Toggle)
Sets the port to operate as a GMRP-aware port. The setting is only valid if
the GMRP Protocol field near the bottom of the screen is set to Enable.
The GMRP field setting toggles between Y (yes) and N (no).
The default is "Y".
To set the port, refer to
4-4
GMRP GVRP
[ y ] [ y ]
[ y ] [ y ]
[ y ]
[ y ]
[ y ] [ y ]
[ y ] [ y ]
[ y ] [ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ]
Set All Ports:
[ Enable ]
PREVIOUS
Figure 4-2 GARP Operation Status Screen
Section
Figure 4-2, is used to enable ports on
Port #
2
4
6
8
10
12
14
16
18
20
[GMRP Enable All]
GVRP Protocol:
NEXT
4.3.1.
Local Management Supplement
GVRP
GMRP
[ y ]
[ y ]
[ y ] [ y ]
[ y ] [ y ]
[ y ] [ y ]
[ y ] [ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ]
[ y ] [ y ]
[ Enable ]
RETURN
EXIT
27621-33