Table of Contents
Advertisement
1.2.2
Screen Format
Since the top part of the screen contains the same type of information (the
name of the screen, the SmartSwitch model number, the firmware
revision, and the BOOT PROM revision), it is not shown in the following
descriptions of the screens. Only the lower portion of the screens is shown
in the following screen descriptions. The name of the screen is shown in
the figure title for each screen.
in a screen.
Event Message Field
Event Message Line
Device Type: 2H252-25
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Operational Mode: [802.1Q SWITCHING]
Clear NVRAM
SAVE
Selection Field
Note:
This shows the location of the cutaway that is used in most of the screen graphics in this
document. The top portion of the screen is cut away to eliminate repeating the same
information in each graphic.The screen title is contained in the figure title for each screen.
Figure 1-3 Example of a Local Management Screen
Local Management Supplement
Figure 1-3
Display Fields
2H252-25 LOCAL MANAGEMENT
00-00-ID-00-00-00
0.0.0.0
255.255.0.0
NONE DEFINED
0.0.0.0
[NO]
IP Fragmentation [ENABLED]
Command Fields
Accessing Local Management
shows an example of the fields
General Configuration
Firmware Revision:
BOOTPROM Revision: XX.XX.XX
Device Date:
Device Time:
Screen Refresh Time:
Screen Lockout Time:
Device Uptime XX D XX H XX M
EXIT
Display Field
Input Fields
XX.XX.XX
03/15/1999
14:23:00
30 sec.
15 min.
RETURN
See
Note
2971_14
1-5
Advertisement
Table of Contents
