Table of Contents
Advertisement
Chapter 3: LM Security Screens for 2H23-50R/2H33-37R Devices
5.
Use the arrow keys to highlight the SendTrap field.
6.
To change the SendTrap setting to NoTrap, press the SPACE bar to
toggle the setting.
7.
To change the security on more than one connector, repeat steps 1
through 6 for each connector. Then proceed to step 8 to save all
settings at once.
8.
Use the arrow keys to highlight the SAVE command.
9.
Press ENTER. The message "SAVED OK" displays and all ports of
the connector are set to the selected operating mode.
If LockedOnAddr is chosen as the Security State, the address
NOTE
of the repeater ports must be configured in the Port Level
Security Configuration screen. Refer to
3.4
PORT LEVEL SECURITY CONFIGURATION
SCREEN
The Port Level Security Configuration screen,
the security of each port of a selected connector.
To access the Port Level Security Configuration screen, use the arrow
keys to highlight the PORT LEVEL SECURITY CONFIGURATION
menu item on the Repeater Configuration Menu screen and press ENTER.
The Port Level Security Configuration screen displays.
3-10
Section
Figure
3-4, is used to set
Local Management Supplement
3.4.
Advertisement
Table of Contents
