Table of Contents
Advertisement
Problem Solving
Check
Is the correct resolution selected?
(Only when projecting computer images)
Is the Sync./Tracking adjusted correctly?
(Only when projecting computer images)
Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)
The image is truncated (large) or small, the aspect is not suitable, or the image has been reversed
Check
Have the Screen been set correctly?
Is the aspect adjusted correctly?
Is Scale turned on?
Is the display range restricted by Blanking?
Is the image position adjusted correctly?
Is the computer set for dual display?
(Only when projecting computer images)
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays"
p.243
s Computer's documentation
Press the [Auto] button on the Remote Control or the [
adjustment. If the images are not adjusted correctly even after performing automatic adjustment, you can also make
adjustments from the Configuration menu.
s Signal - Tracking, Sync.
p.137
The image may be collapsed if the Resolution on the Configuration menu and the resolution of the projected image are
not the same.
If the image is collapsed, set the Resolution to Auto.
s Signal - Resolution
p.137
Make the appropriate Screen for the screen being used.
s "Screen Settings"
p.34
Press the [Aspect] button to select an aspect suitable for the input source.
s "Changing the Aspect Ratio of the Projected Image"
Set Scale to Off on the configuration menu.
s Signal - Scale - Scale
p.137
Appropriately set Blanking in the configuration menu.
s Signal - Blanking
p.137
(Only when projecting analog RGB signals input from the Computer In port and BNC In port)
Press the [Auto] button on the remote control or the [
You can also adjust the position from the Configuration menu.
s Signal - Position
p.137
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver's documentation
Remedy
] button on the Control panel to perform automatic
Remedy
p.77
] button on the control panel to adjust the position.
191
Advertisement
Table of Contents
