Table of Contents
Advertisement
Safety Warning and Cautions
Attention
• When using a clamp to attach the projector to an aluminum truss, attach the
clamp to at least four points so that it is symmetrical with the eight screw
holes for the clamp. When installing using four points, use the following
screw hole combinations. The M6 screws for the clamp must be longer than
10 mm (with a max of 27 mm). You cannot install if the distance between
the center of the aluminum truss pipe and the center does not match the
distance between the screw holes.
s "Appearance"
p.250
• When installing the projector in a high location such as on a wall, hanging
from a ceiling, or an aluminum truss, make sure you take measures against
the projector falling such as attaching a commercially available drop-
prevention wire to the mounting section.
a
• We recommend setting the focus, zoom, and lens shift at least 30
minutes after you start the projection, because images are not stable
right after turning on the projector.
• When adjusting the image height with the vertical lens shift, adjust
by moving the image from the bottom to the top. If it is adjusted
from the top to the bottom, the image position may move down
slightly after adjusting.
Warnings and Cautions on Lifting
Caution
• Use the four eye bolts installed on the same surface of the projector to lift
it.
• Only use the eye bolts when temporarily transporting the projector and not
for permanent installation. The projector could be damaged or could
malfunction.
• Do not lift the projector with the front/back/side of the projector facing
up.
• Make sure that the angle when lifting is 60 degrees or more.
6
Advertisement
Table of Contents
