Table of Contents
Advertisement
Safety Warning and Cautions
Warning
• Do not place flammable objects in front of the lens. If you set the schedule to
turn on the projector automatically, any flammable objects placed in front of
the lens could cause a fire.
• Do not tie the power cord and other connection cables together. Otherwise, it
could cause a fire.
• Only use the specified power-supply voltage. Otherwise, it could cause a fire
or electric shock.
• Be careful when handling the power cord. Otherwise, it could cause a fire or
electric shock. Note the following when handling the power cord.
- Do not plug multiple power cords in a single electric outlet.
- Do not plug in the power cord if there are any foreign substances, such
as dust, stuck to it.
- Make sure you insert the power cord all the way in.
- Do not plug in or unplug the power cord with wet hands.
- Do not pull the cord when unplugging the power cord. Make sure you
hold it by the plug.
• Do not use a damaged power cord. Otherwise, it could cause a fire or electric
shock. Note the following when handling the power cord.
- Do not alter the power cord.
- Do not place any heavy objects on the power cord.
- Do not bend, twist, or pull the power cord forcibly.
- Do not layout the power cord near a heating device.
Caution
Do not place the projector on an unstable surface, such as on an unstable table
or tilted surface. Install the projector appropriately to prevent the projector
from falling.
Otherwise it may cause an injury.
Attention
• Do not install the projector in a location that is subject to vibration or
shock.
• Do not install the projector near a high-voltage line or object that generates
magnetism. Otherwise the projector may not work correctly.
• Do not use or store the projector in a location that is subject to extreme
temperatures. Also, avoid sudden temperature changes.
Make sure you maintain the operating or storage temperature ranges.
s "Projector General Specifications"
• Do not install the projector in direct sunlight. If the projector is in direct
sunlight, the internal temperature increases, which could cause parts such as
the surface of the projection lens or the built-in camera to deteriorate.
• When installing the projector in an environment in which a high-powered
laser beam is being used, make sure it is installed so that the laser beam does
not hit the surface of the projection lens.
• When using at an altitude that exceeds 1,500 m, set High Altitude Mode to
On.
s Extended - Operation - High Altitude Mode
• The projector can be installed at any angle. There is no vertical or horizontal
limit to how the projector can be installed.
• You may need dedicated installation mounts to tilt and install the projector.
Contact a specialist and prepare the mount.
p.245
p.142
4
Advertisement
Table of Contents
