Installing the Projector
Removing and Attaching the Projector Lens Unit
Warning
Make sure you disconnect the power cord from the projector before removing
or attaching the lens unit to the projector. Otherwise, it could cause an electric
shock.
Attaching
Attention
• Do not attach the lens unit when the projector's lens insertion section is
facing up. Dust or dirt could enter the projector.
• Try not to touch the lens section with your hand or fingers. If fingerprints or
oils are left on the surface of the lens, projection quality deteriorates.
a
• The projector supports lens with the following model numbers.
ELPLX02, ELPLX02W, ELPLU03S, ELPLU04, ELPLW06, ELPLW08,
ELPLM10, ELPLM11, ELPLM15, ELPLL08
• In a normal installation, the image may be tilted depending on your
lens. Adjust the tilt of the image using the feet.
s "Adjusting the Tilt (for Normal Installment)"
• For information on installing ELPLX02/ELPLX02W, see the User's
Guide supplied with ELPLX02/ELPLX02W.
a
Loosen the lens cover fixing screw.
Turn the screw by hand.
b
While pressing the top and bottom buttons on both sides of the
lens replacement cover, pull it towards you to remove it.
a
p.43
When using ELPLX02/ELPLX02W, loosen the fixing screw on
the lens replacement cover on the top of the projector, and then
pull the cover towards you to remove it.
30