Table of Contents
Advertisement
Installing the Projector
a
• You can also use the [Focus] buttons, [+] and [-] on the remote
control to adjust the focus. You can also use the [
on the remote control or the control panel while the lens calibration
screen is displayed.
• When projecting from several projectors and there is a difference in
brightness, we recommend displaying the grayscale test pattern and
adjusting the focus.
s "Displaying the Test Pattern"
• If the focus is not correct even after adjusting the focus, press
the [Calibration] button on the remote control to perform lens
calibration. When lens calibration is complete, adjust the focus
again.
Correcting Distortion (Image Warping)
When using a short throw zoom lens and focusing at the center of the
screen, the surrounding image may warp and be out of focus. Follow the
steps below to correct the warping.
a
Press the [Focus] button on the control panel.
b
Press the [ ][ ] buttons to focus the image around the center of
the lens.
][
] buttons
p.35
c
Press the [Distortion] button on the control panel.
d
Press the [ ][ ] button to adjust the focus of the surrounding
area.
41
Advertisement
Table of Contents
