The Image Is Truncated (Large) Or Small, The Aspect Is Not Suitable, Or The Image Has Been Reversed - Epson EB-5535U User Manual

Problem Solving
Check
Is the correct resolution selected?
(Only when projecting computer images)
g g
Are the Sync. and Tracking settings adjusted correctly?
(Only when projecting computer images)
Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)

The image is truncated (large) or small, the aspect is not suitable, or the image has been reversed

Check
Have the Screen been set correctly?
Is the aspect adjusted correctly?
Is a wide panel computer image being projected?
(Only when projecting computer images)
Is the image still being enlarged by E-Zoom?
Is the display range restricted by Blanking?
Is the image position adjusted correctly?
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.209
s Computer's documentation
Press the [Auto] button on the Remote Control or the [
adjustment. If the images are not adjusted correctly even after performing automatic adjustment, you can also make
adjustments from the Configuration menu.
s Signal - Tracking, Sync. p.119
The image may be collapsed if the Resolution on the Configuration menu and the resolution of the projected image are
not the same.
If the image is collapsed, set the Resolution to Auto.
s Signal - Resolution p.119
Make the appropriate Screen for the screen being used.
s "Screen Settings" p.25
Press the [Aspect] button to select an aspect suitable for the input source.
s "Changing the Aspect Ratio of the Projected Image "
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.119
Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)"
Appropriately set Blanking in the configuration menu.
s Signal - Blanking p.119
(Only when projecting analog RGB signals input from the Computer port)
Press the [Auto] button on the remote control or the [
You can also adjust the position from the Configuration menu.
s Signal - Position p.119
Remedy
] button on the Control panel to perform automatic
Remedy
p.62
p.79
] button on the control panel to adjust the position.
168