Table of Contents
Advertisement
Turning On the Projector
Before turning on the projector, connect your computer or video equipment
to the projector.
"Connecting Equipment"
s
Attention
Install the current breaker for 13 A to 20 A to the wiring in the building that
supplies electricity to the projector. Do not connect other devices to the
wiring where the current breaker is installed, and use the wiring only for the
projector.
a
Connect the projector to the power outlet using the power cord,
and then attach the cable holder.
Warning
• There are two types of power cord supplied with the projector, 100 V
and 200 V, depending on your country or region. The power cord you
need to use may differ depending on your operating environment.
Contact a specialist to provide information on handling the power
cord.
p.48
a
You can use the 100 V power cord to operate the projector
temporarily to determine the installation location. When
projecting using the 100 V power cord, the brightness of the
projected image is approximately 55% compared to when using
a 200 V power cord. Use the 200 V power cord when adjusting
the projected image or the lens.
You cannot use the following functions with the 100 V power
cord.
• Light Source Mode
• Estimated Remains
• Light Source Calibration
b
Turn on the main power switch to supply power to the projector.
The projector's power indicator turns blue (it is in standby mode).
This indicates that the projector is receiving power, but is not yet
turned on.
c
Press the [
] button on the control panel or remote control to
turn on the projector.
The confirmation buzzer beeps and the status indicator flashes blue
as the projector warms up. Once the projector is warmed up, the
status indicator stops flashing and turns blue.
If the image is not projected, try the following.
56
Advertisement
Table of Contents
