Table of Contents
Advertisement
Adjusting Projected Images
When Vertical Corner is selected:
Adjust the left and right based on the point nearest to the vertical
line in the center of the screen.
a
If the [Esc] button is pressed for approximately two seconds,
the confirm default reset screen is displayed.
Select Yes to reset the result of Corner Wall.
i
Press the [
][
][ ][ ] buttons to adjust the shape.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
j
Repeat steps 8 and 9 as needed to adjust any remaining parts.
If the image expands or contracts, go to the next step and adjust the
linearity.
k
Press the [Esc] button to display the screen from step 3. Select
Linearity, and then press the [
] button.
l
Press the [ ][ ] buttons to adjust the linearity.
Correct it so that the distance between lines is equal.
When pressing the [ ] button
When Horizontal Corner is selected
When pressing the [ ] button
When Horizontal Corner is selected
m
To complete the corrections, press the [Menu] button.
a
You can fine tune the corrected results. Use Quick Corner to adjust
the tilt of the image, and then use Point Correction for fine tuning.
Select Quick Corner or Point Correction on the screen from step
3.
s "Quick Corner"
p.64
s "Point Correction"
p.72
71
When Vertical Corner is selected
When Vertical Corner is selected
Advertisement
Table of Contents
