Table of Contents
Advertisement
Adjusting Projected Images
f
Use the [
], [
], [ ], and [ ] buttons to adjust the shape.
If the triangle in the direction you are adjusting the shape turns gray,
as shown in the screenshot below, you cannot adjust the shape any
further in that direction.
g
Press the [Esc] button to return to the previous screen.
h
Repeat steps from 5 to 7 as needed to adjust any remaining
parts.
If the image expands or contracts, go to the next step and adjust the
linearity.
i
Press the [Esc] button to return to the screen in step 4. Select
Horizontal Linearity or Vertical Linearity, and then press the [
button.
Select Horizontal Linearity to adjust the horizontal expansion or
contraction, and select Vertical Linearity to adjust the vertical
expansion or contraction.
a
To compensate for expansion or contraction while maintaining
the aspect ratio, set Maintain Aspect Ratio to On. You may not
be able to perform corrections if you set this to On after
correction. In this situation, return the corrections to their
initial values, or reduce the amount of correction, and then try
again.
j
Select the standard line for the adjustments, and then press the
[
] button.
Press the [ ][ ] buttons when selecting Horizontal Linearity, and
the [
][
] buttons when selecting Vertical Linearity, and then
press [
].
The selected standard line is displayed in flashing orange and white.
a
Changing the standard line resets the previous settings.
67
]
Advertisement
Table of Contents
