Table of Contents
Advertisement
Installing the Projector
If the center is out of focus after adjusting the surrounding image,
repeat steps 1 to 2.
a
You can also adjust distortion in images using the remote control.
After adjusting the focus at the center of the lens using the [Focus]
buttons, [+] and [-], use the [Distortion] buttons, [+] and [-] to adjust
the surrounding image.
Registering and Loading Lens Adjustment Values
You can register a lens position whose lens shift, zoom, focus, and
distortion was adjusted in memory, and load it when necessary. You can
register up to 10 values.
a
• If you did not calibrate your lens, a message is displayed when you
save a memory. Select Yes to calibrate the lens.
• The lens position when a memory is loaded may not completely
match the lens position when the memory was saved.
• If there is a large discrepancy between the lens position when a
memory is loaded and the lens position when the memory was
saved, calibrate the lens.
s Extended - Operation - Lens Calibration
a
Press the [Memory] button while projecting.
b
c
p.142
a
You can also operate from the Configuration menu.
s Settings - Memory
p.140
Select Lens Position, and then press the [
Select the function you want to perform, then press the [
button.
Function
Load Memory
Loads the saved memory. When you select a
memory name and press the [
is automatically adjusted according to the settings
of the selected memory.
Save Memory
Registers current settings in the memory. When
you select a memory name and press the [
button, the settings are saved.
42
] button.
]
Explanation
] button, the lens
]
Advertisement
Table of Contents
