The Image Is Truncated (Large) Or Small, The Aspect Is Not Suitable, Or The Image Has Been Reversed - Epson V11H735140 User Manual

Problem Solving

The image is truncated (large) or small, the aspect is not suitable, or the image has been reversed

Check
Have the Screen been set correctly?
Is the aspect adjusted correctly?
Is a wide panel computer image being projected?
(Only when projecting computer images)
Is the image still being enlarged by E-Zoom?
Is Scale turned on?
Is the display range restricted by Blanking?
Is the image position adjusted correctly?
Is the computer set for dual display?
(Only when projecting computer images)
Is the correct resolution selected?
(Only when projecting computer images)
Is the image direction correct?
Make the appropriate Screen for the screen being used.
s "Screen Settings" p.30
Press the [Aspect] button to select an aspect suitable for the input source.
s "Changing the Aspect Ratio of the Projected Image "
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.129
Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)"
Set Scale to Off on the configuration menu.
s Signal - Scale Scale p.129
Appropriately set Blanking in the configuration menu.
s Signal - Blanking p.129
(Only when projecting analog RGB signals input from the Computer port)
Press the [Auto] button on the remote control or the [
You can also adjust the position from the Configuration menu.
s Signal - Position p.129
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver documentation
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.240
s Computer's documentation
Make the correct settings in Projection from the Configuration menu.
s "Installation Settings" p.29
Remedy
p.78
p.109
] button on the control panel to adjust the position.
174