Epson EB-L20002U User Manual page 138

List of Functions
Submenu
(Only available when an analog RGB computer signal is
Resolution
being input.)
Set to Auto to automatically identify the resolution of the
input signal. If images are not projected correctly when set
to Auto, for example if some of the image is missing, set to
Wide for wide screens, or set to Normal for 4:3 or 5:4
screens depending on the connected computer.
Manual allows you to specify the resolution. This is ideal
when connected computer is fixed.
You can set the Aspect Ratio for projected images.
Aspect
s "Changing the Aspect Ratio of the Projected Image"
p.77
(Only available when an analog RGB computer signal is
Tracking
being input.)
You can adjust computer images when vertical stripes
appear in the images.
Function
Submenu
Sync. (Only available when an analog RGB computer signal is
being input.)
You can adjust computer images when flickering, fuzziness,
or interference appear in the images.
Position You can adjust the display position up, down, left, and right
when a part of the image is missing so that the whole image
is projected.
(Only available when an analog RGB computer signal is
Auto Setup
being input.)
Set to On to automatically adjust Tracking, Sync., and
Position to the optimum state when the input signal
changes.
Changes the output image ratio (the range of the projected
Overscan
image). You can set the cropping range to 4% or 8%. When
set to Auto, this is automatically adjusted according to the
input signal.
Blanking
You can hide images in the set area. Use the [ ][ ]
buttons to adjust the area. You can adjust by using a
combination of Top, Bottom, Left, and Right. You can hide
up to half of the projected image in each direction (except
for one pixel).
* (Displayed when the current source is HDMI, DVI-D,
Color Space
HDBaseT, SDI, or DisplayPort)
Sets the color space conversion method. When Auto is
selected, the conversion method is set automatically. Select
BT.709 or BT.2020 if necessary.
138
Function