Table of Contents
Advertisement
List of Functions
Submenu
Geometry Cor-
You can correct distortion.
rection
s "Correcting Distortion in the Projected Image"
• Off:
Temporarily cancels the geometry correction.
• H/V-Keystone:
Adjust V-Keystone, V-Balance, H-Keystone, and H-
Balance to correct vertical and horizontal keystone
distortion.
• Quick Corner:
Select and correct the four corners of the projected image.
• Curved Surface:
Corrects distortion that occurs when projecting on a
curved surface.
• Corner Wall:
Corrects distortion that occurs when projecting on a
surface with right angles.
• Point Correction:
Divides the projected image into a grid and corrects the
distortion by moving the selected point of intersection
from side to side and up and down.
• Memory:
You can save the adjustment value of the geometry
correction and load it when needed.
s "Memory Function"
You can split the screen into two screens.
Split Screen
s "Projecting Two Images Simultaneously (Split Screen)"
p.99
Control Panel Lock: You can use this to restrict operation of the
Lock Setting
projector's control panel.
s "Control Panel Lock"
Lens Lock: When set to On, buttons related to lens operations on
the remote control are disabled.
s "Lens Lock"
Function
p.62
p.104
p.112
p.113
Submenu
Brightness Set-
Light Source Mode: Set the brightness for the light source.
• Normal: Select this if you do not want to decrease the
tings
brightness. This makes the light source operation time
approximately 20,000 hours.
• Quiet: Select this if you are concerned about the noise made by
the fan. This sets the brightness at 70%. This makes the light
source operation time approximately 20,000 hours.
• Extended: Select this to extend the life expectancy of the light
source. This sets the brightness at 70%. This makes the light
source operation time approximately 43,000 hours.
• Custom: Select this to set the brightness level within a range of
30 to 100%.
Brightness Level: (Only available when Light Source Mode is set
to Custom) Sets the brightness for the light source.
Constant Brightness: (Only available when Light Source Mode
is set to Custom) When set to On, the brightness of the light
source set in Brightness Level is maintained as it is. When
Constant Brightness is set to On, you cannot change the settings
for Light Source Mode and Brightness Level.
s "Setting the Brightness"
Estimated Remains: When Constant Brightness is set to On,
this indicates the amount of time for which constant brightness
can be maintained.
s "Guide to Estimated Remains"
You can limit the reception of the operation signal from the
Remote Receiver
remote control.
When set to Off, you cannot perform any operations from the
remote control. If you want to make operations from the remote
control, hold down the [Menu] button on the remote control for
at least 15 seconds to reset the setting to its default value.
Select the items in the Configuration menu that you want to
User Button
assign to the [User1], [User2], and [User3] buttons on the remote
control. The following items can be assigned.
Light Source Mode, Multi-Projection, Resolution, Display the
QR Code, Image Enhancement, Frame Interpolation, Screen
Matching, Color Calibration, Help, Split Screen
141
Function
p.74
p.75
Advertisement
Table of Contents
