Table of Contents
Advertisement
Installing the Projector
Removing
Caution
Wait for a while after turning off the projector before removing the lens unit
(approximately 30 mins.). Touching the lens unit immediately after projecting
or turning off may cause burns.
Attention
If you have used lens shift to move the lens position, move the lens to the
home position and then replace the lens unit.
s "Adjusting the Position of the Projected Image (Lens Shift Adjustment)"
p.37
a
The projector uses a laser as the light source. As a safety measure, the
light source turns off when the lens is removed. Attach the lens, and
then press the [
] button to turn it back on.
a
Loosen the lens cover fixing screw.
Turn the screw by hand.
b
While pressing the top and bottom buttons on both sides of the
lens replacement cover, pull it towards you to remove it.
c
Release the lock if the lever is locked.
Pull up the lever lock, move it to the left, and then push it back
in.
d
While holding the lens unit firmly, hold the lever and turn it
counterclockwise to unlock the lens unit.
Pull the lens unit straight out as it is released.
33
Advertisement
Table of Contents
