Table of Contents
Advertisement
DuraStor 412R/6320SS/7320SS Installation and User's Guide
Basic Configuration – DuraStor 6320SS
The DuraStor 6320SS can be set up to provide a storage solution
with up to 12 disk drives. This configuration uses the primary
RAID enclosure only. If you need to use more disk drives, you can
add up to two additional 412R drive enclosures to the
DuraStor 6320SS storage subsystem.
To set up a basic 12-disk drive configuration
1 Power
the storage subsystem. See
OFF
page
2-7.
2 Remove the SAF-TE disk I/O card installed in the storage
subsystem. (See
instructions.)
3 Locate the switches on the card and set them as shown in either
Figure 2-13
The switch settings assign specific SCSI IDs to the drive slots,
reserving IDs 6 and 7 for the RAID controller(s), and IDs 8 or 15
for the SAF-TE processors.
There are two possible switch settings for this configuration.
You may choose either setting to fit your needs.
SAF-TE ID = 8/8
RAID Controllers = 6 & 7
Switch Settings
A
A
R
S
S
B
0
1
D
0
1
D
1
2
3
4
5
6
Figure 2-13 Dual-Bus Switch Setting – Option 1 (DuraStor 6320SS)
2-12
Replacing an I/O Card on page 5-21
or
Figure
2-14.
Slot 1
Slot 2
D
R
Slot 3
L
M
UP (1)
7
8
DOWN (0)
Turning the Power Off on
Dual-Bus Mode
Slot 4
ID 1
ID 2
Slot 5
ID 3
ID 4
Slot 6
ID 5
ID 0
Dr ive IDs of the Dr ive S lots ( Dr ive C hannel Side)
for
Slot 7
Slot 10
ID 1
ID 2
Slot 8
Slot 11
ID 3
ID 4
Slot 9
Slot 12
ID 5
ID 0
Advertisement
Table of Contents
