Table of Contents
Advertisement
DuraStor 412R/6320SS/7320SS Installation and User's Guide
switch setting is the same for both of these daisy-chained
enclosures. Set the switches as shown in
SAF-TE ID = 15
RAID Controllers = 6 & 7
Switch Settings
A
A
R
S
S
B
0
1
D
0
1
D
1
2
3
4
5
6
Figure C-20 Switch Setting – Single-Bus Daisy-Chain Enclosure
8 (Second & third daisy-chain enclosure) Change the jumper settings
on the SAF-TE Disk I/O card JP7 and JP8 as described.
Locate and add the two jumpers (JP7 and JP8). See
on page 5-17
(installed on both pins) to JP8 for Channel 1 and JP7 for
Channel 2. This will ensure that the automatic termination
feature functions properly.
9 Reinstall the SAF-TE Disk I/O cards in each enclosure. See
Replacing an I/O Card on page 5-21
10 (Second & third daisy-chain enclosure) Install the Single-Bus
Module in the Controller 1 slot in both of these enclosures. For
details, see
Installing the Single Bus Module and Cover Plate on
page
5-9.
11 Connect the SCSI data cables as shown in
C-18
Slot 1
Slot 2
D
R
Slot 3
L
M
UP (1)
7
8
DOWN (0)
for help locating the jumpers. Add a jumper
Figure
Single-Bus Mode
Slot 4
ID 1
ID 2
Slot 5
ID 3
ID 4
Slot 6
ID 5
ID 0
Dr ive IDs of the Dr ive S lots ( Dr ive C hannel Side)
for detailed instructions.
Figure
C-20.
Slot 7
Slot 10
ID 9
ID 10
Slot 8
Slot 11
ID 11
ID 12
Slot 9
Slot 12
ID 13
ID 14
Figure 5-14
C-21.
Advertisement
Table of Contents
