Adaptec DURASTOR 6320SS Manual page 22

Note: In these logical view diagrams, the numbers 1 to 12
represent disk drive slots and are used to indicate which
drives are connected to which channel. They should not be
confused with the disk drive SCSI IDs. Those IDs are pre-
determined by the SCSI disk I/O card switch settings.
Single Bus
Module
Figure 2-6 Logical Diagram – Drive Connectivity, Single-Bus Mode
In dual-bus mode, the channel 1 connector on the SAF-TE disk I/O
card provides access to drives 7 through 12 and the channel 2
connector provides access to drives 1 through 6.
the drive connectivity of the Dual-Bus Mode.
Termination
Termination
Figure 2-7 Logical Diagram – Drive Connectivity, Dual-Bus Mode
To set up a basic 12-disk drive configuration:
1 Power the storage subsystem. See
OFF
page 2-7.
2 Remove the SAF-TE disk I/O card installed in the enclosure.
See Replacing an I/O Card on page 5-21
Drives 7 - 12
Drives 1 - 6
Drives 7 - 12
Drives 1 - 6
Setting Up Your Storage Subsystem
SAF-TE
SEP
SEP
Figure 2-7
SAF-TE
Termination
SEP
Termination
SEP
Turning the Power Off on
for detailed instructions.
Termination
Termination
shows
2-9