DuraStor 412R/6320SS/7320SS Installation and User's Guide
9 Configure the jumper settings on this second daisy-chain
enclosure SAF-TE disk I/O card.
Locate and add (installed on both pins) the two jumpers at JP7
and JP8. The default position of the jumpers are offset.
10 Reinstall the SAF-TE disk I/O card in each enclosure. See
Replacing an I/O Card on page 5-21
11 Connect the SCSI data cables as shown in
SCSI Data Cable
Power
Power
Supply
Supply
Power
Power
Supply
Supply
Power
Power
Supply
Supply
Figure C-12 Enclosure Cabling Diagram
12 Connect a SCSI data cable from the host system(s) HBA(s) to the
host I/O card as indicated in
DuraStor 6320SS on page 2-15
DuraStor 6320SS on page
The configuration is complete. Refer to the Storage Manager Pro
User's Guide or the Disk Array Administrator User's Guide for
instructions on how to set up and configure disk arrays.
C-10
SAFTE Disk I/O
Chl 1
Chl 2
Cooling
SCSI Disk I/O
Fans
Chl 0
Chl 3
Host I/O
P2
P4
P1
P3
Ctlr 1
SAF-TE
Ctlr 2
SAFTE Disk I/O
Chl 1
Chl 2
Cooling
Fans
Ctlr 1
SAF-TE
Ctlr 2
SAFTE Disk I/O
Chl 1
Chl 2
Cooling
Fans
Ctlr 1
SAF-TE
Ctlr 2
Basic Connections –
or
C-21.
for instructions.
Figure
SCSI Data Cable
RAID Controller
SCSI Data Cable
Second daisy chain
enclosure
Single Bus
Module
Advanced Cabling –
C-8.
Primary
enclosure
First daisy-chain
enclosure