Replacing The Battery - Adaptec DURASTOR 6320SS Manual

Replacing the Battery

1 Use your screwdriver to loosen and remove the screws that
secure the top of the canister to the bottom. There are four
screws on each side of the canister and two on the bottom—10
screws in total.
2 Pull the top of the canister away from the bottom, and set it
aside.
3 Align the battery as shown in
canister between the battery posts.
Figure 5-5 Installing the Battery
4 Plug the battery cable into the white, three-pronged connector
on the DuraStor RAID controller. See
5 Place the battery cover over the battery, lining up the three
screw holes with the three battery posts.
6 Use three washer and screw sets to attach the battery cover to
the canister. Do not over tighten the screws.
7 Close the canister and replace the screws.
Understanding and Maintaining Components
Figure 5-5 and place it in the
Figure 5-5.
5-7