Table of Contents
Advertisement
3 Reinstall the SAF-TE disk I/O card in each enclosure. See
Replacing an I/O Card on page 5-21
4 Connect a SCSI data cable from the host system(s) HBA(s) to the
host I/O card as indicated in
on page 2-15
The configuration is complete. Refer to the Storage Manager Pro
User's Guide or the Disk Array Administrator User's Guide for
instructions on how to set up and configure disk arrays.
RAID – 24-Drive Configuration
The DuraStor 6320SS can be setup to provide up to a 24 disk drive
storage solution (12 per channel).
1 Remove the SAF-TE disk I/O card installed in both enclosures.
See
Replacing an I/O Card on page 5-21
2 Locate the switches on each card and set them as shown in
Figure
C-6.
The switch settings assign specific SCSI IDs to the drive slots as
indicated, and reserve IDs 6 and 7 for the RAID controller), and
IDs 8 or 15 for the SAF-TE processors.
SAF-TE ID = 8/8
RAID Controllers = 6 & 7
Switch Settings
A
A
R
S
S
B
0
1
D
0
1
D
1
2
3
4
5
6
Figure C-6 Switch Setting – Primary RAID Enclosure (DuraStor 6320SS)
3 Reinstall the SAF-TE disk I/O card in each enclosure. See
Replacing an I/O Card on page 5-21
or
Advanced Cabling – DuraStor 6320SS on page
Slot 1
Slot 2
D
R
Slot 3
L
M
UP (1)
7
8
DOWN (0)
Advanced Configurations and Cabling
for instructions.
Basic Connections – DuraStor 6320SS
for instructions.
Dual-Bus Mode
Slot 4
ID 1
ID 2
Slot 5
ID 3
ID 4
Slot 6
ID 5
ID 0
Dr ive IDs of the Dr ive S lots ( Dr ive C hannel Side)
for instructions.
C-21.
Slot 7
Slot 10
ID 1
ID 2
Slot 8
Slot 11
ID 3
ID 4
Slot 9
Slot 12
ID 5
ID 0
C-5
Advertisement
Table of Contents
