Adaptec DURASTOR 6320SS Manual page 144

DuraStor 412R/6320SS/7320SS Installation and User's Guide
Controller 1 slot. This single-bus module connects Channel 1 and
Channel 2 together to create a single continuous SCSI bus.
Figure C-1 Logical View of Connectivity – Single-Bus Mode
Note: In Figure
drives are connected to which channel. They should not be
confused with the disk drive SCSI IDs. Those IDs are pre-
determined by the SCSI disk I/O switch settings.
1 Remove the SAF-TE Disk I/O card installed in both enclosures.
See Replacing an I/O Card on page 5-21
2 Locate the switches on each card and set them as shown in
Figure C-2.
There is one switch setting for both enclosures.
Figure C-2 Single-Bus JBOD Switch Setting
3 Reinstall the SAF-TE disk I/O card in each enclosure. (See
Replacing an I/O Card on page 5-21
C-2
C-1, the drive slots are used to indicate which
for detailed instructions.
for detailed instructions.