9 Slide one of the rack's mounting rails into the slot on the left side
of the RAID appliance's back panel. See
Push the rail in until it fits the depth of the rack. The rail should
mate with mounting slots on the rack's rear vertical member
and make the appliance level and tight-fitting.
Rear Rack Vertical Member
Nut
Nut
Figure 2-4 Attaching the Rails
10 Secure the left side rail to the rack's rear vertical member using
the screws and nuts.
11 Repeat steps
Note: Be sure that the RAID appliance is level. Check that
you used mounting slots of the same height on both sides
of the rack.
12 Reinstall the power supplies. See
for detailed instructions.
Mounting
Screws
9
and
10
for the other side rail.
Setting Up Your Storage Subsystem
Figure
2-4.
Replacing a PSU on page 5-14
2-5