Table of Contents
Advertisement
DuraStor 412R/6320SS/7320SS Installation and User's Guide
4 Power
your storage subsystem. See
ON
page 2-7
for instructions.
5 Once everything is powered
operating mode.
By default, the RAID controller's operating mode is set to
active-active single-port. Use Storage Manager Pro or Disk
Array Administrator to change the operating mode. Your
choices are:
Stand-alone single-port. See
I
Stand-alone dual-port. See
I
Active-active single-port. See
I
Active-passive dual-port. See
I
6 Use Storage Manager Pro or Disk Array Administrator to
configure the disk arrays as desired.
Stand-Alone Single-Port: Host Cabling
Choose this topology when your application requires a low-cost
entry-level, fault-tolerant disk storage solution. This solution
provides a single controller configuration that supports a single or
dual host(s), and up to three disk channels.
2-16
Turning the Power On on
, you may need to set the
ON
page
2-16.
page
2-22.
page
2-19.
page
2-20.
Advertisement
Table of Contents
