Table of Contents
Advertisement
Set the communications parameters for the terminal program as
shown in
Table
Table 3-2 Communications Parameter Settings
Setting
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Connector
To access Disk Array Administrator:
1 From the computer connected to the controller, start your
terminal emulator software.
Be sure that your terminal emulator software is set to use the
correct COM port on your computer. Refer to the Adaptec Disk
Array Administrator User's Guide for details on how the
DuraStor 6200S/7200S RAID controller can auto-detect the
baud rate.
2 Press CTRL-R.
The initial Disk Array Administrator screen appears.
3 Press Enter.
The System Menu screen appears.
You can now perform all of the functions described in the Adaptec
Disk Array Administrator User's Guide.
!
Caution: Adaptec recommends that you regularly and
consistently back up your data so that it may be recovered in
the event of a failure that's not protected by a fault-tolerant
array.
3-2.
Value
115,200
8
1
None
None
COM1 (typically)
Accessing Your Storage Management Tools
3-5
Advertisement
Table of Contents
