Table of Contents
Advertisement
4 Install the single-bus module in the Controller 1 slot in both
enclosures. See
page 5-9
for detailed instructions.
5 Connect a SCSI data cable from the host system HBA(s) to the
SAF-TE disk I/O card Channel 1 connectors on each enclosure,
as shown in
Power
Power
Cooling
Supply
Supply
Power
Power
Cooling
Supply
Supply
Figure C-3 Cabling Diagram JBOD Dual Enclosures
The configuration is complete. See
page
2-7.
Installing the Single Bus Module and Cover Plate on
Figure
C-3.
Host Computer
SCSI Data Cable
SAFTE Disk I/O
Chl 1
Chl 2
Fans
Ctlr 1
SAF-TE
Ctlr 2
Single-Bus Mode
SAFTE Disk I/O
Chl 1
Chl 2
Fans
Ctlr 1
SAF-TE
Ctlr 2
Single-Bus Mode
Advanced Configurations and Cabling
Single Bus
Module
SCSI Data Cable
Single Bus
Module
Turning the Power On on
C-3
Advertisement
Table of Contents
