Preparing The Disk Drive For Installation; Installing A Disk Drive - Adaptec ACS-120 User Manual

Preparing the Disk Drive for Installation

Before installing the disk drive, ensure that it meets the
requirements listed in
Set the drive jumper to Master or Device 0 mode (or equivalent, as
described on your disk drive), following the instructions on your
disk drive.

Installing a Disk Drive

Note: You need a Phillips screwdriver to complete this task.
To install a disk drive into your USB Enclosure:
1 Use a screwdriver to remove the enclosure cover, as shown
below.
2 Connect the EIDE/IDE connector of your disk drive to the
interface connector inside the enclosure cover.
Interface Connector
Supported Disk Drives on page
Disk Drive Connector
7
5.