Table of Contents
Advertisement
ID61/62 Series Panel - Installation, Commissioning & Configuration Manual
1
Introduction
1.1 Manual Purpose
The purpose of this manual is to provide the user with all
recommended procedures and full technical details for
the successful installation, commissioning and
programming of a NOTIFIER ID61/62 Series Panel.
Features of the ID61/62 Series fire control such as
VIEW™, Optiplex/SMART 2, SMART 3 and SMART 4
sensors, which require a fuller explanation of their
enhanced fire detection capabilities, are described in
Appendix 2 of this manual.
Procedures described in this manual include appropriate
warnings and cautions to guide the user towards adopting
safe and methodical work practices during the installation,
commissioning and programming phases.
The ID61/62 Series panels support OPAL protocol
devices. These devices support both OPAL and CLIP
loop polling protocols so they can be added to an existing
CLIP protocol loop. However, when OPAL protocol is
enabled on a loop a maximum of 10 CLIP devices
addresses can be supported as part of the total of 99
sensors and 99 modules.
Important Note
This manual must be read, and its content clearly
understood, before proceeding with any work relating to
the ID61/62 Series Panel. Damage to the control panel
may result from NOT following the recommended
procedures described in this manual.
This manual provides all necessary instructions for the ID61/
62 Series Panel and applies only to fire panels fitted with
compatible software.
CAUTION: In particular, care must be taken when
powering up/down any repeaters.
If there are any areas of doubt, consult your supplier
before continuing with the system installation,
commissioning and programming.
1.2 System Design and Planning
It is assumed that the system, of which the ID61/62 Series
Panel equipment is a part, has been designed by a
competent fire alarm system designer in accordance with
the requirements of EN 54 Part 14 and any other local
codes of practice that are applicable.
The design drawings should clearly show the positions
of all the ID61/62 Series Panel control equipment and
field devices.
1
997-457-000-8, Issue 8
January 2010
Advertisement
Table of Contents
